Product Details
Water Based Wood Floor Sealer
- Quick-drying, sandable after 120 minutes
- Reduces side-bonding
- Minimizes penetration of tannic acid
- Gives the wood a light colour
- Topcoat with WOCA Optima
Application Instructions
Instructions
It is important that both wood and product have a temperature of min. 59°F (preferably around 68°F) and air humidity of approximately 40-60 %. Make sure that the room is well-ventilated for optimal evaporation and drying time. Untreated floors must be free of dirt, grease, wax and dust. Floors that have been finished previously must be sanded down to bare wood before the sealer is applied. Vacuum thoroughly and tack the floor afterwards if necessary, using a tightly-wrung water-soaked cloth. Shake the Natural Sealer thoroughly before use.
Always remember to test on a less visible spot to check the compatibility of the surface with the product.
- Apply sealer undiluted with brush or roller, lengthwise, and allow the surface to dry.
- Sand the surface with 120-180 grit and vacuum clean the surface thoroughly.
- Apply a 1 coat of WOCA Water Based Finish. Leave the surface to dry until next day.
The next day, apply another 1-2 coats of WOCA Water Based Finish (refer to specific WOCA Water Based Finish product for recommended number of coats).
Note: When using a WOCA Sealer, only 2 coats can applied each day, either 2 coats of Sealer OR 1 coat of Sealer and 1 coat of WOCA Water Based Finish.
Maintenance & Cleaning
Do not place furniture etc. on the floor until at least 24 hours after the final coat of floor finish. The floor will be ready for normal use after approx. 5-7 days, after which rugs etc. can be placed on the floor. If drying times are not followed, this can result in poor adhesion and reduced resistance. For each coat of floor finish, drying times will be increased. High temperature and low air humidity will reduce drying times. Low temperature and high air humidity will extend drying times.
Technical
Technical
| VOC | 75 g/l (max) |
| Shelf Life | 2 years |
| pH | 7-8 |
| Application temperature | 15-25°C and approx. 50% air humidity. |
| Coverage | 325-490 sq ft/gal |
| Odour | faint |
| Colours | Colourless (Satin) |
| Cleaning of Tools | water |
| Storage | 10-25°C Keep out of reach of children. Do not expose to heat (e.g. sunlight). Store frost-free during winter and cool during summer. |
| Packaging | 1 Gal (+ 2oz Hardener) |
| Viscosity | <25-30 Sec. DIN Cup 4 |
| Solid Content | 30-40% |
| Drying Time | 1-2 hrs at 20°C |
Download
Related Products
